CanoRemote Manual

Receiver Initialisation

After a battery change, the mode of the remote receiver must be set. The receiver can be set to 3 modes according to the table. It remains in this mode until the battery is changed or removed. To select the mode, insert the battery and press one of the following buttons for at least 1second on the remote.

	for CHDK standard (receiver answers with 1 long & 1 short pulse)
+	for CHDK fast (receiver answers with 1 long & 4 short pulses)
MENU	for Ricoh fast (receiver answers with 1 long & 3 short pulses)

This has to be done from a distance of approx. 3cm from the receiver. The receiver answers with a blink code of the status LED when the button on the remote is released.

Receiver Wakeup

After a certain timeout of inactivity the receiver enters the sleep mode. To wake it up from sleeping press any key on the remote from a distance of approx. 3cm to the receiver. The receiver answers with a blink code of the green status LED.

Configuring the Sleep Timer

The sleep timeout can be configured in 5 steps: 2 (default), 5, 10, 15, 30 minutes. To enter the configuration menu press the MENU button on the remote for at least 1 second. The receiver indicates the mode with the green LED, which is permanently on. Now it is possible to select the sleep time with the + and - button on the remote. The remote indicates the mode with blink codes (1x 2min., 2x 5min. ...). To exit press MENU on the remote for at least 1 second.

Receiver Modes

	CHDK standard mode	CHDK fast mode	Ricoh Mode
	Pulse 400ms	Pulse 150ms	Shoot full
	Pulse 160ms	Pulse 60ms	SDM Time lapse mode
	Pulse 80ms	Pulse 30ms
+	Pulse 240ms	Pulse 90ms
-	Pulse 320ms	Pulse 120ms
MENU	2sec. delay then Pulse 480ms	2sec. delay then Pulse 180ms	Shoot half